Open reduction - Compression plating

Humeral shaft fractures may be treated with compression plating under the following conditions:

• Reduction and stability not achieved with other techniques, particularly in older children
• Open fractures
• Neurovascular injuries
• Polytrauma

The principles of fixation are identical to adult fracture management.

The plate should allow for insertion of a sufficient number of screws on either side of the fracture.

Plates that accommodate the smaller pediatric humerus are available. A 3.5 or 4.5 mm LCP or DCP is recommended depending on the bone size.

Open fractures may dictate the surgical approach and the plate position.

The position and contouring of the plate are dictated by the location of the fracture in relation to the soft-tissue attachment and its proximity to the axillary and radial nerves.

The course of the radial nerve in relation to the plate holes should be documented to reduce the risk of nerve injury associated with plate removal.

A posterior plate is preferred for middle and distal third fractures.

An anterolateral plate may be selected for proximal and middle third fractures.

Place the patient in a supine position or, alternatively, a beach chair position for an anterolateral plate.

Place the patient prone or in a lateral decubitus position for a posterior plate.

The approach depends on the plate position.

For an anterolateral plate, the anterolateral approach is used.

The posterior surface is accessed with a posterior approach.

Reduce the fracture with traction and manipulation.

Intraoperative imaging and clinical evaluation should confirm good axial and rotational alignment.

The plate can be used as a reduction aid.

Preliminary K-wire fixation may be used to hold the reduction.

If a DCP is used, the plate should be contoured to match the anatomy of the bone and some overbending is required for compression.

This is not required if an LCP is used.

Apply the plate in a standard manner, avoiding periosteal stripping.

For more details on compression plating, see the following basic technique:

• Plating principles in pediatric fracture care

Insert the remaining screws.

A sling may be used initially, but early mobilization is recommended.

The first clinical and radiological follow-up is usually undertaken within 2 weeks.

X-rays are repeated after 6 weeks.

Implant removal is not mandatory and is associated with a high risk of radial nerve injury.