The distal medial entry point is an alternative and useful in midshaft and proximal 1/3 fractures of the ulna.
Opening the canal
Use small scissors or a surgical clip and small retractors to dissect to the bone under direct vision.
Place the awl or drill directly onto the bone and perforate the near cortex, under direct vision, perpendicular to the bone.
Do not hammer the awl to avoid perforation of the far cortex.
When the medullary canal is reached, lower the awl or drill 45° to the shaft axis and advance it with oscillating movements to produce an oblique canal.
Pitfall: Entry point through the olecranon
Do not introduce the nail through the olecranon.
This does not enhance fixation and causes troublesome soft-tissue irritation.
Precontouring the nail for forearm shaft fractures may be required.
The medullary canal is small and the nail may deform during insertion.
Fix the nail into the inserter and pass it into the canal.
Pearl: insertion of nail tip perpendicular to shaft
Insert the nail with the tip perpendicular to the shaft axis until the far cortex is felt. Rotate the nail 180° and advance it using the curved side of the tip as a gliding aid.
If the tip is stuck in the far cortex and cannot be advanced, remove the nail and bend the tip to give a slightly more pronounced curvature.
Advancing the nail
Advance the nail to the fracture site with an oscillating maneuver.
Pearl: A short working length (3-5 cm) between the entry point and the inserter improves control of the nail during insertion.
Pitfall: iatrogenic fracture
In young children, the nail tip may become stuck because of the narrow medullary canal.
Do not use a hammer if the nail is stuck as this risks iatrogenic fracture.
Withdraw by 2 cm, rotate the nail to free the tip and continue advancing.
Reduction with nail
Point the nail tip toward the opposite fracture plane and advance the nail into the distal fragment. At this point gentle hammer blows may prevent the nail from advancing into the soft tissues. Rotate the tip to reduce the fracture.
Advance the nail for 2-3 cm and rotate the nail back to the initial position.
Reduction can be aided by increasing the deformity to allow fracture surface contact using the nail as a joystick.
In case of a wedge fracture (22u-D/5.2), sufficient bone contact is necessary for axial stability avoiding redisplacement and telescoping. If there is length instability the use of end caps is recommended.
The major fragments are reduced and the wedge fragment is not disturbed.
If the nail cannot be advanced into the distal fragment, manipulate the fracture by distraction and rotation of the forearm and check using image intensifier.
This may reduce the fracture in both planes and allows the nail to advance.
If the nail cannot be advanced after three attempts, open the fracture zone for reduction and advance the nail into the distal fragment under direct vision.
If an image intensifier is not available, an open procedure is necessary.
Make a small skin incision over the fracture zone followed by a small incision in the deep fascia.
The fracture often causes soft-tissue stripping, and the fracture fragments are located with blunt finger dissection.
Insert two small retractors so that both fracture ends are visible.
Pearl: Before opening the fracture, a threaded K-wire may be used to manipulate the proximal fragment.
Pitfall: risk of compartment syndrome
Repeated attempts to achieve closed reduction and fixation may increase the risk of compartment syndrome.
The compartment status should be checked within 6 hours.
Final nail insertion
Advance the nail down to the strong metaphyseal bone at the level of the distal ulna.
Place the forearm in supination with the nail tip rotated towards the radius to tension the interosseous membrane.
Pearl: estimation of nail length
If an image intensifier is not available, estimate the optimum nail length with a second identical nail placed parallel to the initial nail.
Cutting the nail and wound closure
Cut the nail near the bone.
If a dedicated nail cutter is not available, cut the nail slightly shorter as the end will be sharper and this prevents skin perforation.
Gently withdraw the nail by 1 cm, cut the nail outside the skin and reinsert to the original position with an impactor.
Close the subcutaneous tissue and skin in a standard manner.
5. Option: end caps
End caps may be useful for stabilizing length unstable fractures.
The nail should finally be advanced using the beveled impactor.
A small end cap can be screwed in over the nail using the inserter.
6. Final assessment
Check the completed osteosynthesis with image intensification. These images should be retained for documentation or alternatively an x-ray should be obtained before discharge.
Make sure that the desired reduction has been achieved and the nail is of appropriate length.
7. Aftercare following ESIN
Immediate postoperative care
Whilst the child remains in bed, the forearm should be elevated on pillows to reduce swelling and pain.
They should be encouraged to use the arm.
Cast immobilization is not necessary and hinders early recovery of joint movement.
For Monteggia lesions treated with ulnar nailing, the forearm may be immobilized in a cast in the position of maximum stability of the radiocapitellar joint for 2-4 weeks.
Ibuprofen and paracetamol should be administered regularly during the first 4-5 days of injury, with additional oral narcotic medication for breakthrough pain.
If pain is increasing the child should be examined.
The child should be examined regularly, to ensure finger range of motion is comfortable and adequate.
Neurological and vascular examination should also be performed.
Compartment syndrome should be considered in the presence of increasing pain, especially pain on passive stretching of muscles, decreasing range of active finger motion or deteriorating neurovascular signs, which are a late phenomenon.