Authors of section

Authors

Alex Vaccaro, Frank Kandziora, Michael Fehlings, Rajasekaran Shanmughanathan

Executive Editor

Luiz Vialle

General Editor

German Ochoa (in memoriam)

Open all credits

Posterior short segment fixation with pedicle screws

1. Introduction

Preliminary remarks

B1 injuries indicate monosegmental pure osseous failure of the posterior tension band. They are also called Chance fractures. The vertebral body and the posterior tension band have failed in flexion distraction mode through the bony structures.

Thoracic and lumbar fractures: Posterior short segment fixation with pedicle screws

Repair of dural laceration

More details on repair of dural laceration can be found here.

2. Patient preparation and approach

The posterior open approach to the midline is used together with the appropriate patient preparation.

posterior short segment fixation with pedicle screws

3. Closed reduction

Primary reduction is performed by positioning of the patient onto a frame to create lordosis.

Thoracic and lumbar fractures: Posterior short segment fixation with pedicle screws

4. Reduction with pedicle screws

Preliminary remarks

Due to the fact that bilateral instrumentation is necessary in all cases, all steps described below are repeated on the opposite side, unless described otherwise.

Thoracic and lumbar fractures: Posterior short segment fixation with pedicle screws

Pedicle screw insertion

Most B1 fractures, being pure osseous disruptions, have excellent healing potential and can be managed by posterior short segment fixation with pedicle screws alone.

Pedicle screws are inserted into the vertebrae cephalad and caudal to the fracture level on both sides. Mono- or polyaxial, top- or side loading screws can be used in any combination. ( Pedicle Screw Insertion)

Thoracic and lumbar fractures: Posterior short segment fixation with pedicle screws

Rod contouring

The contouring of the rod depends on the site of the fracture following the natural curvature of the spine. A rod contoured in mild kyphosis is chosen for fractures from T1-T10. A straight or a slightly lordotic rod is chosen for fractures from T11-L1 as illustrated, and a rod contoured to lordosis is chosen for lumbar fractures.

Thoracic and lumbar fractures: Posterior short segment fixation with pedicle screws

Rod insertion

The rods are introduced to the distal screw heads on both sides and tightened.

Thoracic and lumbar fractures: Posterior short segment fixation with pedicle screws

The rod is then inserted into the proximal screw heads without tightening.

Thoracic and lumbar fractures: Posterior short segment fixation with pedicle screws

The screw heads are tightened with the inner nuts to secure the reduction achieved.

Thoracic and lumbar fractures: Posterior short segment fixation with pedicle screws

The final construct is shown from a lateral view.

Thoracic and lumbar fractures: Posterior short segment fixation with pedicle screws

5. Fusion

Decision

Although fusion was routinely performed for all spinal fractures, its indications are now being restricted to fractures that are highly unstable.

Nonfusion fixations can be performed for A3, A4, and B1 type injuries. Fusion is routinely performed for A2, B2, B3 and all C injuries as they are unstable injuries with extensive soft tissue and ligamentous disruption.

Nonfusion

For nonfusion surgeries, the facet joint capsule is preserved during the entire procedure.

The screws can be removed after 9 months once the fracture has healed.

Thoracic and lumbar fractures: Posterior short segment fixation with pedicle screws

6. Intraoperative imaging

Prior to wound closure, intraoperative imaging is performed to check the adequacy of reduction, position, and length of screws and the overall coronal and sagittal spinal alignment.

Thoracic and lumbar fractures: Posterior short segment fixation with pedicle screws

7. Aftercare for posterior procedures

Patients are made to sit up in the bed on the first day after surgery. Bracing is optional. Patients with intact neurological status are made to stand and walk on the second day after surgery. Patients can be discharged when medically stable or sent to a rehabilitation center if further care is necessary. This depends on the comfort levels and presence of other associated injuries.

Thoracic and lumbar fractures: Aftercare for anterior procedures

Patients are generally followed with periodical x-rays at 6 weeks, 3 months, 6 months, and 1 year. Normally, 5-10 degrees of loss of kyphosis can be observed within the first 6 months, which does not affect the functional outcomes. For nonfusion surgeries, the implants can be removed once fusion is confirmed.

Thoracic and lumbar fractures: Aftercare for posterior procedures