Andrew Howard, Theddy Slongo, Peter Schmittenbecher
The end cutter is useful to avoid sharp ends and soft-tissue irritation.
Ring fixator wires may be used.
Bend the tip by approximately 30° to provide a gliding aid.
For optimal reduction and intramedullary three-point fixation, the nail diameter should be between 60% and 70% of the medullary canal.
Preliminary reduction is not useful as deformity often recurs following manipulation.
The proximal lateral entry point is in common use.
The distal medial entry point is an alternative and useful in midshaft and proximal 1/3 fractures of the ulna. It is shown in this procedure.
Use small scissors or a surgical clip and small retractors to dissect to the bone under direct vision.
Note: Avoid injury to the superficial ulnar nerve and the basilic vein.
Place the awl or drill directly onto the bone and perforate the near cortex, under direct vision, perpendicular to the bone.
Do not hammer the awl to avoid perforation of the far cortex.
When the medullary canal is reached, lower the awl or drill 45° to the shaft axis and advance it with oscillating movements to produce an oblique canal.
Precontour the nail to reproduce the geometry of the bowing deformity.
Fix the nail into the inserter and pass it into the canal.
Insert the nail with the tip perpendicular to the shaft axis until the far cortex is felt. Rotate the nail 180° and advance it using the curved side of the tip as a gliding aid.
If the tip is stuck in the far cortex and cannot be advanced, remove the nail and bend the tip to give a slightly more pronounced curvature.
Advance the nail into the strong metaphyseal bone with an oscillating maneuver.
The precontouring and bowing should be in the same plane.
Pearl: A short working length (3-5 cm) between the entry point and the inserter improves control of the nail during insertion.
In young children, the nail tip may become stuck because of the narrow medullary canal.
Do not use a hammer if the nail is stuck as this risks iatrogenic fracture.
Withdraw by 2 cm, rotate the nail to free the tip and continue advancing.
If an image intensifier is not available, estimate the optimum nail length with a second identical nail placed parallel to the initial nail.
Rotate the nail 180° to counteract the deformity and re-anchor the tip in the cortex.
Full realignment of deformity may take several days.
Complete reduction with the nail may not be possible in the following cases:
In this situation, a small osteotome can be used to divide the bone through a small incision over the apex of the bowing.
Cut the nail near the bone.
If a dedicated nail cutter is not available, cut the nail slightly shorter as the end will be sharper and this prevents skin perforation.
Gently withdraw the nail by 1 cm, cut the nail outside the skin and reinsert to the original position with an impactor.
Close the subcutaneous tissue and skin in a standard manner.
End caps may be useful for stabilizing length unstable fractures.
The nail should be finally advanced using the beveled impactor.
A small end cap can be screwed in over the nail using the inserter.