Specific consideration for the distal humerus is given below.
Note on illustrations
Throughout this section, generic fracture patterns are illustrated as:
C) Reduced and provisionally stabilized
D) Definitively stabilized
Option: hinged external fixator
A hinged external fixator is rarely indicated as the distal humeral segment is not stable enough to support motion. In rare instances, it may be used for combined distal humerus and proximal ulnar articular injuries.
Nerves around the distal third of the humerus
Nerves on both sides of the distal humerus run very close to the bone, especially the ulnar nerve, which perforates the medial intermuscular septum runs and then in its sulcus behind the medial epicondyle. It can be directly compressed in distal humeral fractures. The radial nerve perforates the lateral intermuscular septum as it follows the spiral groove on the humerus to run anteriorly and distally. At the level of the radial head, it divides into its deep and superficial branches.
Note: The median nerve crosses the anterior capsule of the elbow joint, running into the forearm between the two heads of the pronator teres.
For temporary stabilization with an external fixator, the pins should be outside the planned internal fixation zone (see illustration).
The humeral pins may be inserted in the region of the deltoid insertion zone to avoid the radial nerve.
This will also avoid the zone of soft-tissue injury.
4. Pin insertion
If pins are placed more distally, the following precautions should be taken to avoid nerve injuries.
Blunt dissection of the soft tissues and the use of small (Langenbeck) retractors will prevent damage to muscular, vascular, and neurological structures.
Prepare a channel for insertion of the pin, using a blunt clamp down to the bone. If there is any doubt, perform an incision big enough to prove that the drill sleeve (for the humerus a must) will have direct contact with the bone.
The radial nerve passes into the anterior compartment of the arm through the lateral intermuscular septum at the junction of the 3/5 and 4/5 of the humerus. Preoperative planning of the pin tracks helps to avoid damage to the nerve.
Use the fixator to align the upper extremity. This reduces stress on the neurovascular structures and soft-tissue envelope.
Anatomical reduction is not the goal of this procedure.
Tighten the clamps to secure the alignment of the limb.
A rod can be added for additional stability, spanning from the most proximal to the most distal pin.
The arm is supported in a “collar-and-cuff” sling for comfort.
Proper pin insertion
To prevent postoperative complications, the pin-insertion technique is more critical than any pin-care protocol:
Correct placement of pins (see safe zones) avoiding ligaments and tendons, eg, the triceps aponeurosis
Correct insertion of pins (eg, trajectory, depth) avoiding heat necrosis
Extending skin incisions to release soft-tissue tension around the pin insertion (see inspection and treatment of skin incisions)
Various aftercare protocols to prevent pin-track infection have been established by experts worldwide. Therefore, no standard protocol for pin-site care can be stated here. Nevertheless, the following points are recommended:
The aftercare should follow the same protocol until the removal of the external fixator
The pin-insertion sites should be kept clean; any crusts or exudates should be removed; the pins may be cleaned with saline and/or disinfectant solution/alcohol; the frequency of cleaning depends on the circumstances and varies from daily to weekly but should be done in moderation
No ointments or antibiotic solutions are recommended for routine pin-site care
Dressings are not usually necessary once wound drainage has ceased
Pin-insertion sites need not be protected for showering or bathing with clean water
The patient or the carer should learn and apply the cleaning routine
Pin loosening or pin-track infection
In case of pin loosening or pin-track infection, the following steps need to be taken:
Remove all involved pins and place new pins in a healthy location
Debride the pin sites in the operating theater, using curettage and irrigation
Take specimens for a microbiological study to guide appropriate antibiotic treatment if necessary
Before changing to a definitive internal fixation, an infected pin track needs to heal. Otherwise, infection will result.
In the rare event that external fixation has been used as the definitive management of a distal humeral fracture, there is a significant risk of marked stiffness of the elbow joint. A prolonged rehabilitation program under the supervision of the surgeon and an experienced physical therapist will be necessary.
See the patient one week after surgery for a wound check. X-rays are taken to check the alignment.