Authors of section


Andrew Howard, Theddy Slongo, Peter Schmittenbecher

Executive Editor

James Hunter

General Editor

Fergal Monsell

Open all credits

ESIN of the radius after plating of the ulna (Monteggia equivalent)

1. Instruments and implants

Instrument set for ESIN

  • 1.5-2.5 and occasionally 3.0 mm elastic nails
  • Alternatively: 30 cm long, 1.6-2.5 mm K-wires with the tip bent
  • Awl or drill
  • Inserter
  • Nail cutter
  • Small hammer
  • End caps (optional)
ESIN - Instrument set

The end cutter is useful to avoid sharp ends and soft-tissue irritation.

ESIN - End cutter

Use of K-wires

Ring fixator wires may be used.

Bend the tip by approximately 30° to provide a gliding aid.

ESIN - Use of K-wires

Nail diameter

For optimal stability, the nail diameter should be between 60% and 70% of the medullary canal.

2. Opening the canal

Use small scissors or a surgical clip and small retractors to dissect to the bone under direct vision.

Note: Avoid injury to the superficial radial nerve and the cephalic vein.

Place the awl or drill directly onto the bone and perforate the near cortex, under direct vision, perpendicular to the bone.

Do not hammer the awl to avoid perforation of the far cortex.

When the medullary canal is reached, lower the awl or drill 45° to the shaft axis and advance it with oscillating movements to produce an oblique canal.

ESIN (radial neck) - Opening the canal

3. Nail insertion

Precontour the first 5 cm of the nail as this enhances reduction of the displaced radial head.

Produce a sharp tip by cutting the inner end of the nail.

This facilitates entry into the hard bone of the epiphysis.

The manufactured blunt end will displace the radial head.

Some surgeons prefer to use a sharp K-wire with a bent tip.

ESIN (radial neck) - Precontouring the nail

Fix the nail into the inserter and pass it into the canal.

ESIN (radial neck) - Nail insertion

Pearl: insertion of nail tip perpendicular to shaft

Insert the nail with the tip perpendicular to the shaft axis until the far cortex is felt . Rotate the nail 180° and advance it using the curved side of the tip as a gliding aid.

If the tip is stuck in the far cortex and cannot be advanced, remove the nail and bend the tip to give a slightly more pronounced curvature.

ESIN (radial neck) - Nail insertion

Advance the nail to the fracture site with an oscillating maneuver.

Pearl: A short working length (3-5 cm) between the entry point and the inserter improves control of the nail during insertion.

ESIN (radial neck) - Advancing the nail

Pitfall: iatrogenic fracture

In young children, the nail tip may become stuck because of the narrow medullary canal.

Do not use a hammer if the nail is stuck as this risks iatrogenic fracture.

Withdraw by 2 cm, rotate the nail to free the tip and continue advancing.

ESIN - Iatrogenic fracture

4. Reduction

Orientation of forearm and nail

Rotate the arm to obtain the maximal displacement of the neck fracture on the image intensifier.

Point the nail tip to the head fragment.

Closed reduction

If the radius does not reduce spontaneously after reduction and fixation of the ulna, ensure that the ulna is accurately aligned and consider overcorrection.

If after ulnar fixation the radial shaft remains displaced and does not allow the nail tip to be advanced into the head, attempt partial reduction of the fracture by traction, pressure, and rotational movements.

If this is not successful, remove the radial nail and recontour the first 3-4 cm with a more pronounced bend and reinsert it.

ESIN (radial neck) - Closed reduction

Open reduction

If there is residual displacement of the radial neck fracture after optimization of the ulnar correction, an open reduction should be performed.

Open reduction may also be necessary if an image intensifier is not available or if soft-tissue structures are trapped between the fragments.

A lateral approach to the proximal radius may be used to visualize the radial neck fracture.

Note: The risk of avascular necrosis of the radial head is higher after open reduction which should be avoided if possible.

ESIN (radial neck) - Open reduction

5. Fixation

Following partial reduction, advance the nail into the head.

Turn the nail in the direction that anatomically reduces the radial shaft onto the head.

If reduction is not anatomical, withdraw the nail tip to the metaphysis, turn it back to the initial position, advance it and repeat the reduction maneuver.

This correction should only be performed once.

Perforate the growth plate in Salter-Harris I and II fractures to obtain sufficient hold in the head fragment. A sharpened tip is helpful to fix the nail in the final position.

In metaphyseal fractures, the tip of the nail is usually anchored in the head fragment, provided the nail is of the correct length.

In very proximal metaphyseal fractures, perforate the growth plate to obtain sufficient hold.

Most of the head is unossified and not radiologically visible in young children.

If the tip of the nail is advanced just beyond the visible ossification center, it will be within the chondral tissue and not in the joint.

Pearl: If the ossification center is not visible on a normal x-ray an arthrogram should be performed .

ESIN (radial neck) - Fixation

6. Cutting the nail and wound closure

When using the lateral entry point, cut the nail near the bone.

If a dedicated nail cutter is not available, cut the nail slightly shorter as the end will be sharper and this prevents skin perforation.

Gently withdraw the nail by 1 cm.

The risk of redisplacement is low because of the pressure of the radial head on the capitellum.

Cut the nail outside the skin and reinsert to the original position with an impactor.

Ensure that the nail tip does not irritate the superficial radial nerve.

When using the dorsal entry point, the nail should be left long or protected with small end cap to prevent rupture of the extensor pollicis longus.

ESIN (radial neck) - Cutting the nail

Close the subcutaneous tissue and skin in a standard manner.

ESIN (radial neck) - Wound closure

7. Option: end caps

End caps may be useful for protection of soft tissues (eg EPL).

The nail should be advanced using the beveled impactor.

A small end cap can be inserted over the nail using the inserter.

ESIN (radial neck) - End caps
Go to diagnosis