A long leg cast may be necessary for unstable injuries of the distal tibia and fibula.
The cast may be applied in two stages, initially over the leg and foot and then extending to the upper thigh with the knee flexed.
This initially controls the ankle and facilitates casting of the thigh with the knee in the correct position.
If severe swelling prevents application of a circumferential cast, a temporary splint may be applied as an alternative.
With the knee flexed, apply padding around the leg and slabs of casting material posteriorly, covering half of the circumference.
Secure the splint with an elastic bandage.
This is typically changed to a below-knee walking cast when the fracture is sufficiently stable.
The water temperature should ideally be between 22° and 25° C.
An assistant supports the leg with knee flexion.
The distal edge of the cast extends to the base of the toes. The proximal edge lies just below the groin.
Apply a tubular bandage and cut it slightly longer than the length of the final cast.
The assistant holds the toes, not the stockinette, with the ankle in a neutral position.
Consider adding thick felt or additional padding at the free edges of the cast and prominent areas (eg, fibular head, patella, tibial crest, malleoli, and heel) to prevent pressure sores.
Apply cast padding without creases, overlapping each layer by 50%.
It should be appreciated that, when more padding is applied, there will be less support at the injury site.
The assistant holds the ankle in a neutral position if the fracture configuration allows.
Apply the first layer of cast material and overlap each layer by 50%.
Avoid sharp edges at the ends of the cast. Make sure the upper end of the cast is well below the popliteal fossa.
Apply further layers of cast material to produce sufficient stability.
Fold the tubular bandage and padding over the lower edge of the cast before applying the final layer of casting material to the leg.
Remove the triangular support.
Do not increase knee flexion while applying the upper part of the cast. This prevents injury to the skin behind the knee by the edge of the lower cast.
Extend the cast to include the thigh, overlapping the upper part of the leg cast.
Fold the tubular bandage and padding over the upper edge of the cast before applying the final layer of casting material to the thigh.
After cast application, check the fracture configuration with x-rays in both planes.
Parents/carers should understand the following precautions and instructions:
Non-weight-bearing or touch weight-bearing is encouraged for unstable injuries.
Older children may be able to use crutches or a walker.
Younger children may require a period of bed rest followed by mobilization in a wheelchair.
Routine pain medication is prescribed for 3–5 days after injury if required.
The patient should be examined frequently to exclude neurovascular compromise or evolving compartment syndrome.
The first clinical and radiological follow-up is usually undertaken 5–7 days after injury to confirm fracture stability.
Physeal and metaphyseal fractures heal rapidly, and the cast is typically removed 3–6 weeks after injury.
After cast removal, graduated weight-bearing is usually possible.
Patients are encouraged to start range-of-motion exercises. Physiotherapy supervision may be necessary in some cases but is not mandatory.
Activities that involve running and jumping are not recommended until full recovery of local symptoms.
All patients with distal tibial physeal fractures should have continued clinical and radiological follow-up to identify signs of growth disturbance.
Compare alignment and length clinically with the uninjured leg.
A Harris growth arrest line, parallel to the physis, is radiological evidence of continuation of normal growth.