Authors of section

Author

Rémy Liechti

Reviewer

Inese Breide

Executive Editor

Simon Lambert

Open all credits

Palmar approach to the IP joint of the thumb

1. Indications

The palmar approach to the interphalangeal (IP) joint is indicated for intraarticular fractures of the palmar base of the distal phalanx, eg, caused by avulsion injuries of the flexor pollicis longus tendon.

Palmar approach to the IP joint of the thumb: skin incision

2. Surgical anatomy

The base of the distal phalanx has a prominent dorsal crest at the insertion of the extensor tendon. The tendon is also adherent to the IP joint capsule.

The flexor pollicis longus tendon is inserted into the palmar surface of the distal phalanx.

The flexor tendon occupies the whole width of the base of the distal phalanx. It is made up of two different fibers. The superficial fibers attach to the lateral aspects of the phalanx. The deep fibers run centrally and attach more distally on the palmar aspect of the phalanx.

The volar plate is very flexible, allowing hyperextension of the IP joint and pulp-to-pulp pinch.

The vascularity of the extensor tendon is more precarious than that of the flexor tendons. This prolongs extensor tendon healing time.

Note: The volar plate lies immediately deep to the flexor pollicis longus tendon. Division of the volar plate should be avoided.
The digital nerve and artery should be identified and protected.
Palmar approach to the IP joint of the thumb: Surgical anatomy

3. Skin incision

Make a carefully planned palmar angled skin incision (Bruner zigzag), using the flexor skin crease as a guide, as illustrated. The apex of the angle should be at the distal flexor crease, level with the IP joint.

Palmar approach to the IP joint of the thumb: skin incision

Elevate the angled skin flap by sharp dissection in the thin subcutaneous tissue and retract the apex. Identify and carefully mobilize the digital arteries and nerves within the skin and subcutaneous fascial flaps.

The flexor pollicis longus tendon and the oblique and A2 pulleys are now visible.

Pearl: Elevate the Bruner skin flaps using a No. 15 blade, beginning at the apex of the flap. Perform a very superficial subcuticular dissection to safely protect the neurovascular bundle. Upon reaching the mid-portion of the finger (over the flexor tendon sheath), deepen the dissection to include the subcutaneous tissue.
Palmar approach to the IP joint of the thumb: Elevate the angled skin flap

4. Further dissection

Make a blunt dissection of the pulp.

Divide the A2 pulley laterally near its bony attachment, leaving enough for later reattachment (at least 2 mm).

Pitfall: Do not cut the oblique pulley, as it is essential for active IP joint flexion.
Palmar approach to the IP joint of the thumb: dissection of the pulp

5. Elevation of the pulley flap

Elevate the pulley flap and retract it to expose the flexor tendon. By retraction of the tendon, the palmar aspect of the IP joint and the distal phalanx is exposed.

Palmar approach to the IP joint of the thumb: Elevation of the pulley flap

6. Wound closure

Reattach the A2 pulley using fine mattress sutures before skin closure.

Alternatively, the A2 pulley can be left unrepaired as it does not contribute significantly to the control of thumb flexion. This also avoids additional scarring.

Close the skin in a standard manner.

Palmar approach to the IP joint of the thumb: Reattach the A2 pulley
Go to diagnosis