Authors of section

Authors

Aida Garcia, Fabio A Suarez

Executive Editor

Simon Lambert

Open all credits

Supine patient position

1. Introduction

The patient is usually in a supine position with the arm on a radiolucent hand table.

Patient place supine with the arm on a hand table

2. Preoperative preparation

For surgery, the operating surgeon needs to know:

  • Details of the patient (including a signed consent form and appropriate antibiotic and thromboprophylaxis)
  • Patient positioning
  • Comorbidities, including allergies
  • Site and side of the fracture
  • Ensure that the operative site is marked
  • Type of operation planned (percutaneous or open approach)
  • Implants to be used
  • Condition of the soft tissues

3. Anesthesia

  • General anesthesia
  • Regional nerve block
  • Combination of nerve block and light general anesthesia
Pitfall: Use of local anesthetic combined with adrenaline must be avoided. Adrenaline will cause vasoconstriction, leading to ischemia distal to the injection particularly if a finger tourniquet is also used.

Prophylactic antibiotics are optional.

Alternatively, the patient stays awake with local anesthesia (WALANT) without a tourniquet. This allows active movement of the hand and fingers during the operation, especially to check for alignment.

4. Patient positioning

Position the patient supine and place the forearm on the radiolucent hand table.

As the hand will tend to be semisupinated internally, rotate the shoulder to allow the hand to be placed in an appropriate pronated position for a dorsal approach.

Supinate the forearm for a palmar approach.

In unusual circumstances, a combined dorsal and palmar approach may be required.

A pneumatic tourniquet is recommended.

Patient place supine with the arm on a hand table

The affected finger may be suspended in a finger trap to apply traction, assist in reducing fragments and/or dislocations, and permit arthroscopic approaches.

Fingers in finger traps to apply traction

C-arm positioning

The image intensifier should be positioned to not interfere with the operating surgeon’s access to the surgical field.

Patient place supine with the arm on a hand table and C-arm coming from laterally

If a finger trap is used, a small image intensifier may be helpful.

Finger in finger traps and position of a small image intensifier

Skin disinfecting and draping

Disinfect the entire hand, wrist, and arm with the appropriate antiseptic right up to the limits of the tourniquet cuff. This allows full exsanguination.

Preparation of the entire upper limb allows repositioning during surgery.

A protective specific tourniquet exclusion drape can be used to avoid tracking of antiseptic solution under the tourniquet while in use: if alcohol-based antiseptic is used, skin damage can occur from prolonged contact with soaked material during surgery.

Patient place supine with the arm on a hand table and disinfected

A single-use occlusive hand drape with an expandable arm opening is recommended to isolate the upper limb.

Drape the image intensifier.

Patient place supine and draped with the arm on a hand table and disinfected

Operating room set-up

The surgeon sits beside the patient’s head to gain a good view and access to the dorsum of the hand. If a volar approach needs to be performed, the surgeon sits on the opposite side of the arm table.

The assistant sits opposite the surgeon. The ORP sits at the end of the hand table.

Place the image intensifier screen in full view of the surgical team and the radiographer.

Operating room set-up for operating at the level of the hand and wrist
Go to diagnosis