Authors of section

Authors

Renato Fricker, Matej Kastelec, Fiesky Nuñez, Terry Axelrod

Executive Editor

Chris Colton

Open all credits

Nonoperative treatment

1. Indications for nonoperative treatment

Undisplaced, or minimally displaced, fractures of the metacarpal shaft can be treated nonoperatively.
Most of these fractures produce a flexion deformity and often minimal shortening. If the flexion deformity exceeds 10-20 degrees in fractures of the second and third metacarpals, or 20-30 degrees in fractures of the fourth and fifth metacarpals, ORIF is recommended. Shortening of less than 2 mm does not interfere with function, but more than 5 mm can not be accepted.

Undisplaced or minimally displaced fractures of the metacarpal shaft can be treated nonoperatively. Most of these fractures ...

Irreducible rotational malalignment is an indication for ORIF.

Rotational malalignment is an indication for ORIF.

2. Reduction

Displacement usually occurs as a flexion deformity that can be reduced by exerting pressure on the metacarpal head from the palmar aspect, either directly, or using the proximal phalanx as a piston.

Displacement usually occurs as a flexion deformity which can be reduced by exerting pressure from the palmar side on the ...

Especially in spiral oblique fractures, shortening of the metacarpal is associated with rotational malalignment. Reduction, therefore, is achieved by a combination of longitudinal traction on the finger and derotation.

There is a high risk of secondary redisplacement, indicating ORIF as the treatment of choice in such cases.

Especially in spiral oblique fractures, shortening of the metacarpal is associated with rotational malalignment. Reduction ...

3. Option 1: Immobilization with palmar splint

A splint may be applied with the hand in an intrinsic plus (Edinburgh) position and the wrist in slight extension of 20-30 degrees.

In compliant patients, only the fractured finger ray and the two adjacent rays are included in the splint, in fractures of the third, or fourth, metacarpal. In fractures of the second metacarpal, it may be sufficient to include only the second and third rays. In fractures of the fifth metacarpal, the fifth and fourth rays are included.
The splint is held in place with an elastic bandage. The bandage should not be overtightened at the level of the wrist joint, so as to avoid excessive swelling of the hand.

Direct skin contact of adjacent fingers should be prevented by placing gauze pads between them.
This splint is easy to apply and needs no hand therapy during the period of immobilization. A potential disadvantage of this technique is the complete immobilization of uninjured fingers and joints.

A splint may be applied with the hand in an intrinsic plus position and the wrist in slight extension.

4. Option 2: Immobilization with a forearm cast and finger splint

A standard forearm cast is applied, including the wrist joint in 30 degrees of extension, and the aluminium splint is incorporated in the cast. This aluminium splint must be pre-bent to 90 degrees proximal to the level of the MCP joint of the injured finger. The finger is taped to this splint in an intrinsic plus position. Correct rotational alignment must be checked. The other fingers are not immobilized.

The cast must only be applied once the initial swelling has abated, usually a few days after the injury.

A standard forearm cast including the wrist joint in 30 degrees of extension is applied.

Correct bending of the aluminium splint and correct fixation of the splint in the cast are difficult but essential. The bend for the flexion of the MCP joint is more proximal than often perceived. There is a risk of excessive pressure and later ulceration of the soft tissues at the level of the bend if it is too distal.

The advantage of this technique is that only the injured finger is immobilized. Usually hand therapy is not necessary.
Another advantage is that this technique helps maintain length in shortened fractures, but there is less control over rotation than with immobilisation of the adjacent rays (Option 1).

A standard forearm cast including the wrist joint in 30 degrees of extension is applied.

5. Option 3: Attelle fonctionelle

This splint comprises 3 parts:

  • A dorsal splint maintaining the wrist in 30 degrees of extension and the MCP joints in full flexion, reaching distally to the PIP joints
  • A palmar splint supporting the wrist in 30 degrees of extension, reaching the distal flexion crease of the palm
  • A “buddy splintage,” or strapping (syndactylisation), applied at the middle phalanges II-V.

This technique allows immediate mobilization of the interphalangeal joints of all fingers. Its application, however, is difficult, and correct exercising must be supervised by a hand therapist. “Buddy splintage,” prevents rotational malalignment.

This technique allows immediate mobilization of the interphalangeal joints of all fingers.

6. Postoperative splint

X-ray checks of fracture position have to be performed immediately after the splint has been applied.

Follow-up check x-rays in the splint should be taken after 1 week, and possibly after 2 weeks. Immobilization is continued until about 4 weeks after the injury. At that time an x-ray without the splint is taken to confirm healing. Splinting can then usually be discontinued and active mobilization is initiated. Functional exercises are recommended.

If after 8 weeks radiographs confirm healing, full manual loading can be permitted.

nonoperative treatment